Description
Rear Brake Kit for 1 Pc Dragster Housing with Forged Rotors & DRM-35 Metallic Pads
Designed Specifically For Drag Racing
Pro Series Rear Brake Kit
For Strange one-piece aluminum Dragster housing (Strange Engineering H1151 / Strange Engineering H1161 / Strange Engineering H1152 / Strange Engineering H1162)
Requires:
• Ball style axle bearings
• 2.832″ brake offset
For 2.332″ offset: Strange Engineering B1158WCM
One-Piece Forged Steel Rotors – Strange Engineering B2792 / Strange Engineering B2793
- Directional slots increase air flow and reduce weight
- One-piece design eliminates bolts & safety wire
- Hat section drilled & milled to further reduce weight
- 4 1/2″, 4 3/4″ & 5″ Uni-Lug bolt circles for both 1/2″ & 5/8″ studs
Four-Piston Directional Calipers – Strange Engineering B5002 / Strange Engineering B5004
- Aluminum bodies drastically reduce weight
- 1.625″ & 1.750″ pistons vary pressure, decreasing pad taper
- Stainless steel pistons resist corrosion
- Anti-rattle clips reduce brake pad vibration and noise
DRM-35 Metallic Brake Pads – Strange Engineering B5020
- Provides high resistance to brake fade
- Recommended for vehicles going over 150 MPH in the 1/4 mile
- Maintains decent starting-line cold holding capabilities
- May leave pad residue on rotors when not using parachute
- While common, it’s recommended to remove when installing new pads
Aluminum Caliper Mounts
- Billet one-piece design
- Eliminates bolts, spacers & nuts that require periodic maintenance
Housing End Bolt Kit
- Provides additional components not supplied in most aftermarket kits